지원사업
학술연구/단체지원/교육 등 연구자 활동을 지속하도록 DBpia가 지원하고 있어요.
커뮤니티
연구자들이 자신의 연구와 전문성을 널리 알리고, 새로운 협력의 기회를 만들 수 있는 네트워킹 공간이에요.
논문 기본 정보
- 자료유형
- 학술저널
- 저자정보
- 저널정보
- 국제구조공학회 Structural Engineering and Mechanics, An Int'l Journal Structural Engineering and Mechanics, An Int'l Journal Vol.83 No.3
- 발행연도
- 2022.8
- 수록면
- 305 - 326 (22page)
이용수
초록· 키워드
오류제보하기
To realize the recycling utilization of waste concrete and alleviate the shortage of resources, 11 specimens of steel reinforced recycled concrete (SRRC) filled circular steel tube columns were designed and manufactured in this study, and the cyclic loading tests on the specimens of columns were also carried out respectively. The hysteretic curves, skeleton curves and performance indicators of columns were obtained and analysed in detail. Besides, the finite element model of columns was established through OpenSees software, which considered the adverse effect of recycled coarse aggregate (RA) replacement rates and the constraint effect of circular steel tube on internal RAC. The numerical calculation curves of columns are in good agreement with the experimental curves, which shows that the numerical model is relatively reasonable. On this basis, a series of nonlinear parameters analysis on the hysteretic behaviors of columns were also investigated. The results are as follows: When the replacement rates of RA increases from 0 to 100%, the peak loads of columns decreases by 7.78% and the ductility decreases slightly. With the increase of axial compression ratio, the bearing capacity of columns increases first and then decreases, but the ductility of columns decreases rapidly. Increasing the wall thickness of circular steel tube is very profitable to improve the bearing capacity and ductility of columns. When the section steel ratio increases from 5.54% to 9.99%, although the bearing capacity of columns is improved, it has no obvious contribution to improve the ductility of columns. With the decrease of shear span ratio, the bearing capacity of columns increases obviously, but the ductility decreases, and the failure mode of columns develops into brittle shear failure. Therefore, in the engineering design of columns, the situation of small shear span ratio (i.e., short columns) should be avoided as far as possible. Based on this, the calculation model on the skeleton curves of columns was established by the theoretical analysis and fitting method, so as to determine the main characteristic points in the model. The effectiveness of skeleton curve model is verified by comparing with the test skeleton curves.
목차
등록된 정보가 없습니다.
참고문헌 (0)
참고문헌 신청함께 읽어보면 좋을 논문
논문 유사도에 따라 DBpia 가 추천하는 논문입니다. 함께 보면 좋을 연관 논문을 확인해보세요!
-
Finite element analysis and axial bearing capacity of steel reinforced recycled concrete filled square steel tube columns
Structural Engineering and Mechanics, An Int＇l Journal
2019 .01
-
Experimental study on seismic performance of steel reinforced concrete T-shaped columns
Steel and Composite Structures, An International Journal
2020 .01
-
Numerical analysis and horizontal bearing capacity of steel reinforced recycled concrete columns
Steel and Composite Structures, An International Journal
2016 .01
-
Seismic performance of mixed column composed of square CFST column and circular RC column in Chinese archaized buildings
Steel and Composite Structures, An International Journal
2018 .01
-
Buckling resistance of axially loaded square concrete-filled double steel tubular columns
Steel and Composite Structures, An International Journal
2022 .06
-
Behavior of steel-concrete jacketed corrosion-damaged RC columns subjected to eccentric load
Steel and Composite Structures, An International Journal
2018 .01
-
Study on seismic performance of SRC special-shaped columns with different loading angles
Steel and Composite Structures, An International Journal
2022 .09
-
Axial compression mechanical properties of steel reinforced recycled concrete column exposure to temperatures up to 800ºC
Steel and Composite Structures, An International Journal
2021 .12
-
Stress-transfer in concrete encased and filled tube square columns employed in top-down construction
Steel and Composite Structures, An International Journal
2016 .01
-
Mechanical properties of reinforced-concrete rocking columns based on damage resistance
Structural Engineering and Mechanics, An Int＇l Journal
2021 .12
-
Mechanical behaviour of composite columns composed of RAC-filled square steel tube and profile steel under eccentric compression loads
Steel and Composite Structures, An International Journal
2021 .01
-
Eccentric strength and design of RC columns strengthened with SCC filled steel tubes
Steel and Composite Structures, An International Journal
2015 .01
-
An approach for partial strengthening of circular RC columns using outer steel tube
Steel and Composite Structures, An International Journal
2021 .01
-
Experimental and numerical study on fire resistance of tubed steel-reinforced concrete stub columns under eccentric compression
Steel and Composite Structures, An International Journal
2021 .11
-
Simplified Design Procedure for Reinforced Concrete Columns Based on Equivalent Column Concept
International Journal of Concrete Structures and Materials
2016 .09
-
전단파괴가 발생한 기둥의 이력거동 예측을 위한 매개변수 결정방법 제안
한국지진공학회 논문집
2017 .01
-
Study and design of assembled CFDST column-beam connections considering column wall failure
Steel and Composite Structures, An International Journal
2021 .01
-
Mechanical properties and bearing capacity of CFRP confined steel reinforced recycled concrete columns under axial compression loading
Structural Engineering and Mechanics, An Int＇l Journal
2021 .08
-
Structural performance of reinforced concrete wall with boundary columns under shear load
Structural Engineering and Mechanics, An Int＇l Journal
2020 .01
-
Boundary Conditions and Fire Behavior of Concrete Filled Tubular Composite Columns
International journal of high-rise buildings
2018 .01
이 논문의 저자 정보
최근 본 자료
댓글(0)
0